24V RC Diy Net Boat MY6812 Power Set
24V RC DIY net boat MY6812 power set
When installing, all the propellers need to be soaked in water, so that the thrust is greater.
The sealing ring is installed on the motor shaft, and it is fixed and sealed with the hull to prevent water ingress.
Installation attention.
1.The steering gear needs to be connected to the main board to control the rotation before installing the dispenser bracket.
The steering gear signal cable is connected to the main board plug, and the yellow corresponds to the s-pin plug.
2. Install the extension shaft coupling and paddle fork, and add glue to the inner hexagon screws to avoid loosening the screws later.
The driveshaft slipped, and the propeller was lost.
3. The propeller angle is installed clockwise on the right and counterclockwise on the left.
4. Motor debugging, forward throttle, left and right propellers are blowing, then it is correct. If there is no wind, connect this motor to the 2 wires of the main board and exchange the position.
5. After installation, test the function, and test the waterproofing of the whole ship. For the first time, the sailor catches the boat and increases the throttle to test whether the battery is protected. If it is the main board to protect the power off. Then rotate the blue protection valve of the main board to rotate right to adjust it. If the throttle is powered off and the main board has no signal light, you can reconnect after power off, then the battery output current is too small. Need to change the battery.
6. The purchase of a 6s lithium battery requires a power battery, the current needs to drive a 300w motor, and the output current needs to be 30A.
More current. The capacity can be 10ah - 30ah larger, only the ship space can fit,
Set, use 24v voltage (without battery, bring your own 6s lithium battery 25.2v voltage)
MY6812Motor, voltage 24v single motor 150w 3300 rpm.
Shipping accessories list: as follows
A set of RX40E remote control
MY6812 motor 150w x 2a
Waterproof box x1a
Delivery device x1a
50A switch x1a
Voltage display x1a
Sealing ring x2a
Mounting screws x6
2 extension shafts
80Mm three-leaf propeller x1 pair (positive + negative)
