JDMODEL JDM‑212A JDM‑212B Nylon Front Rear Axle for 1/8 1/10 RC Crawler Upgrade Parts

JDMODEL

$157.00

Taxes incluses. Frais de port calculés à la caisse.

I. Model and Basic Information
Model: JDM-212A (Front Axle), JDM-212B (Rear Axle)
Series: Thunder Hammer Miller Series
Material: High-strength engineering nylon (lightweight, impact-resistant, and break-resistant)
Scale: 1/8, 1/10 Climbing Cars / Tube Frame Cars / DIY Models
Gear Ratio: 1:2.6 (low gear ratio, suitable for high-torque climbing)
Output Shaft: 5mm diameter
Connector: Compatible with 12mm hex and Thunder Hammer flanges
Axle Width: Approximately 251mm (distance between connector end faces)
II. Core Structure and Functions
Front Axle (JDM-212A)
Steering Structure: Kingpin inclination + caster design, providing more stable steering and better return-to-center
Differential: Built-in open differential (can later install lock differential servo)
Steering Link Mount: Pre-drilled standard holes, compatible with most linkages and servo layouts
Rear Axle (JDM-212B)
Differential: Open differential, can be installed in forward or reverse, adapting to forward/reverse transmission boxes
Structure: No steering, pure drive, axle housing is one-piece formed for high strength
Common Features
Axle housing with reinforcing ribs, enhancing torsional and impact resistance
Pre-drilled mounting positions for shock absorbers, linkages, and anti-roll bars, compatible with mainstream climbing chassis
Lightweight (nylon material), reducing unsprung mass and improving suspension response
III. Compatibility and Installation Notes
Compatible Vehicles
Static Thunder Hammer Series tube frame cars / climbing cars
1/8, 1/10 DIY climbing, tube frame, and simulation off-road models
Compatible with most 1/10 climbing transmission boxes (e.g., TRX-4, Chopper, etc.)
Installation Tips
Front Axle: Requires pairing with a steering servo and linkage; pay attention to kingpin angle and steering travel
Rear Axle: Differential forward/reverse installation must match the transmission box output direction to avoid reversal
Connector: 12mm hex is universal; flanges require Static-specific hubs